[ Chinese wardrobe network ] Home furniture maintenance has always been our concern, especially for some wood-like furniture, maintenance must pay more attention. One of our most used furniture in the bedroom we live in should be the closet . The door of the closet is the most vulnerable in our daily repeated switch, which is very important for his maintenance.
First of all, the wooden thing must be moisture-proof and anti-corrosive, because the wooden furniture is easy to rot, so for the maintenance of the wardrobe door, we must avoid the moisture of the door and some corrosive chemicals remaining on it. In the process of wiping the wooden door, use a clean rag as much as possible, preferably without a damp cloth and a cleaning agent with chemicals.
Secondly, long-term sunlight will also have a certain impact on the door, and will also affect the paint on the door. Therefore, it is best to place the closet in a place where the sun is not directly exposed.
In addition, it is not easy to put too many things in the closet, because sometimes this will have a certain impact on the switch of the door, which will make the door easy to deform.
Improper handling of paint
The deformation of the deformed parts of the panel furniture parts causes deformation. In the production, some operators conveniently arrange the boards, or the boards of the stacked boards are not flat, and the other ones lean against the wall. This causes the panel to deform due to its own weight before entering the next process. The coating process causes deformation During the finishing process, due to improper use of the process and raw materials, the plate is deformed and deformed as the internal stress of the coating changes. The effect of finishing putty In the decoration of the door parts, many manufacturers use pig blood putty or glue to prepare the putty in order to reduce the cost. Because these two kinds of putty contain a lot of water, the substrate commonly used for plate furniture - medium density Fibreboard and particleboard are particularly hygroscopic, so when one side of the door panel is not putty, and the other side is coated with such a water-rich putty, the door panel part is hygroscopic and deformed.
Effect of the drying process
Many manufacturers are in production. When the board is coated with putty or paint, it should be placed on the drying rack for natural drying. If the rod of the drying rack is too sparse or uneven, the door parts will be dried in the paint. Bending deformation was found during the process. The influence of the internal stress of the coating will form a certain coating after curing. Even if there is no external force, an internal stress will be generated. If the internal stress is not handled properly, it will become the main cause of bending deformation of the door component. one.
Guangdong Jishengke Industrial Co.,Ltd , https://www.jskpads.com