[ Chinese wardrobe network ] Many customers after purchasing a custom closet , do not understand the installation process, today Xiaobian to everyone to track the whole process of custom wardrobe installation, together with the custom wardrobe installation steps!
After receiving the custom closet, first put the inspection and acceptance needs in front. After the installation, the owner can also carry out some tests on his own to find the problem and solve it in time.
1, horizontal and vertical. All horizontal planes should be flat and all facades should be vertical.
2. For panel furniture, all gaps, such as the gap between the door panels, the gap between the drawers, and the gap between the cabinet and the cabinet should be within 2 mm. Solid wood furniture is required to be slightly lower due to its characteristics of shrinkage and swelling, but the gap cannot exceed 4 mm.
3. The damper drawer and the sliding door are pushed and pulled smoothly, and do not slide back and forth. Where should the door be pushed?
First, the material is on the scene: more formal furniture manufacturers, the board is generally shipped with cardboard packaging. After unpacking, check the plates and hardware.
Second, the fixing screws: the nails are generally left in the design according to the design drawings, and the workers at the site use special tools to fix the screws.
Third, the cutting side panel: Since the wardrobe is placed on the wall, the side panel should be sawn off at the position of the baseboard. After you have it, look it up and see if it fits.
4. Place the bottom plate: The floor placed on the floor of the closet should be cleaned beforehand, because it will be very troublesome to clean up after installation. Fixing frame: Install the side and back panels of the closet according to the grooves on the board to adjust the position between the boards.
V. Installation of the top plate: It is best to prepare a climbing stool for the scene. The top plate should be lifted up and then fixed with rivets.
Sixth, install the shelf: Place the shelf to the place where the screws are pre-punched, and then fix it. Pay attention to the fixed position of the shelf and the back and side panels.
Seven, fixed door rail: the door rail is installed on the top and bottom of the wardrobe, the material of the door rail is better, light and firm.
8. Install the clothes rail: Fix the fixed rivets in the reserved position and install the clothes rail. Note that the two sides should be balanced.
Nine, install the door leaf: two sliding doors should be attached to the position of the guide rail, first fix the door leaf and then fix the guide rail of the bottom side, so as to avoid the phenomenon that the door leaf falls off in the future.
X. Adjustment and improvement: After all the installations are completed, make a “full inspection†of the wardrobe. If there is any deviation, adjust it in time.
XI. Completion of the acceptance: Finally, check the wardrobe: Shake the cabinet to see if it is firm and the details are in place.
Vintage Paper Napkins,Serviette Tissue,Custom Paper Napkins,Fancy Paper Napkins
Baoda Paper Enterprise Co., Ltd. , https://www.baodatissue.com